For most residential wiring.

Eccentric knockouts, non-metallic and non-conductive. Can be mounted to wood or steel studs. 3.53 in H x 2.10 in W x 3-1/4 in D.

Used where multiple conductor runs are split into two or more directions to bring power to a number of electrical devices. Drawn construction and raised grounding provision for exposed work or surface mount applications. Combination cover screw heads provide for faster mud ring/cover installation. Twelve 1/2 in conduit knockouts (sides). Four 1/2 in conduit knockouts (bottom). No bracket. 4 in square x 1-1/2 in deep and 21 cu-in capacity. UL listed, acceptable for use in 2 hrs fire rated walls. UPC bar code.

Designed to enclose electrical wiring, switches, receptacles or lighting fixtures. Constructed from 1/16 in pre-galvanized steel. 8-32 cover mounting screws assembled.

Designed to enclose electrical wiring, switches, receptacles or lighting fixtures. Constructed from 1/16 in pre-galvanized steel.

With lugs. Die-cast aluminum. For use in branch circuit wiring in wet, damp or dry locations. May be used as a weatherproof junction box or as housing for receptacles, switches and GFCI's. Eight box mounting options with detachable lugs provided. 2 in deep, three 3/4 in threaded outlets. 32 cu-in capacity. Powder coat finish. Two closure plugs included. Ground screw installed. Internal threads and hubs comply with NEMA requirements. Hubs accept all threaded fittings and threaded conduit. UL listed, CSA Approved and NEMA 3R Rated.

Raised gang box device covers/rings are used in finish wall applications to mount switches or receptacles. Raised 3/4 in for commercial wall applications. Additional keyholes allow device covers to also fit next smaller box (example: A 3-gang cover will fit a 2 or 3 gang box). 8-7/8 in x 4-1/2 in x 3/4 in.

For use in branch circuit wiring in wet, damp or dry locations. Designed for use as a weatherproof junction box and used with Bell round cluster covers and round lamp holder combinations. Die-cast aluminum construction. Powder coat finish. Reinforced connector outlets. Cast-in mounting lugs, four closure plugs included and installed ground screw. 16.1 cu-in capacity. Six 10-24 tapped holes. 4 in Dia x 1-1/2 in D. UL listed.

RACO RECEPT SINGLE VERT OUTLET

RACO SGL 4HOLE 1/2 KN OUTLET

RACO OUTLET BOX 2X4 2-1/2 DEEP

RACO OUTLET BOX 4X4 2-1/2D 1/2 &

RACO OUTLET BOX 3GA 2-1/2DP 1/2

RACO OUTLET MASON 3G BOX 3-1/2 D